09-18-2017, 09:10 PM
Some battery replacements on some laps must be setup from the BIOS, using hardware detection. Leave your new battery in place, and reset the BIOS to factory defaults. As it begins the I/O read prior to boot it should detect the battery LV on the board if it is good. Don't forget to reset your cmos clock after defaulting.
TC
TC
All opinions expressed and all advice given by Trinidad Cruz on this forum are his responsibility alone and do not necessarily reflect the views or methods of the developers of Linux Lite. He is a citizen of the United States where it is acceptable to occasionally be uninformed and inept as long as you pay your taxes.