See the Security and Bug Fixes Section - Grub EFI Install Updates Fix Sticky


Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LL6.0 installs but after update get X.509 error @boot; LL6.6 install screws PC
#7
Couple of notes:
1) Generally Windows can still be installed in legacy mode (dosMBR tables) however once installed you cannot switch to UEFI mode or vice versa just because the option is there in the BIOS. It's kind of you must pick one or the other and stick with it. If Windows was UEFI to begin with, then Linux should be installed for dual booting UEFI. This could be in part the cause of some of the boot problems you had.

2) Another culprit could be forgetting to shut Windows completely down before booting back into Linux. Hold down the shift key without releasing it and select shut down and don't release the shift key until Windows goes off, or use powershell to completely shut down. In your case I'd bet on a combination of these first two things I mention here.

3) I don't dual boot anymore anyway, nor do I advise others to. Virtualization is a better solution and Linux Lite runs quite nicely in hyper-v.

4) When I did dual boot and share a partition I used exFAT as it seemed quicker.

5) Anyway I hope your dual boot does what you need it to do.

best of luck
TC   
All opinions expressed and all advice given by Trinidad Cruz on this forum are his responsibility alone and do not necessarily reflect the views or methods of the developers of Linux Lite. He is a citizen of the United States where it is acceptable to occasionally be uninformed and inept as long as you pay your taxes.
Reply


Messages In This Thread
Re: LL6.0 installs but after update get X.509 error @boot; LL6.6 install screws PC - by trinidad - 02-06-2024, 04:15 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)